Outboard Motor Stand
Reviews by category
-
Great investment motor fits on nicelyThe only down fall is the board 2x10 is cracked where they put one set of drill holes.I will have to replace the board at some point but otherwise very sturdy. Makes moving and storing a lot easier.
-
Thus is a solid design, 10 minutes start to finish to assemble. Nice to see good hardware with self locking nuts. Depending on which motor your mounting, you may want to consider lowering the board to bring the CoG down a bit.
-
I have a small - 2.5 hp - boat motor that I needed a better way to store - this item fit the bill just fine. It was easy to put together in spite of not so included instructions. I went by the photo from the web site and basically had few problems figuring out what went where. I am very pleased with this item - would recommend.
-
Product is perfect for it’ Intended purpose. Strong enough to easily hold 30 hp motor for storage or moving. I use it to keep my motor inside during the winter. When motor goes back on boat folds up for easy storage.
-
Thus is a solid design, 10 minutes start to finish to assemble. Nice to see good hardware with self locking nuts. Depending on which motor your mounting, you may want to consider lowering the board to bring the CoG down a bit.
-
Product is perfect for it’ Intended purpose. Strong enough to easily hold 30 hp motor for storage or moving. I use it to keep my motor inside during the winter. When motor goes back on boat folds up for easy storage.
-
Product is perfect for it’ Intended purpose. Strong enough to easily hold 30 hp motor for storage or moving. I use it to keep my motor inside during the winter. When motor goes back on boat folds up for easy storage.
-
Howdy, the stand could be much easier to assemble if parts were actually called out with sizes AND had a decent groove in slot for a driver.That being said, when you dump the parts out take a marker and actually measure them and mark the longest ones. Itll save a bunch of time.I took this 150 pound beast and clamped it to the board and strapped it so it wouldn't turn and rolled it upright using the rounded edges of the stand.Image shows a 1960 merc kiekhaefer 400s next to a 1865 ish boat.Would I buy it again?Yes, in fact I just did for another project....Actually had to buy from another source as these folks were out.
-
Perfect fit for my 5hp Nissan/Tohatsu. It's pretty well built and sturdy enough tilt the engine with no problems. In a review someone had suggested finding a picture of one online to help with assembly. I would like to thank them! With the included directions and Picture it was pretty straight forward. It took about 30mins to put together.It fit easily though a standard door frame and the handle folds down for storage. You can turn the engine sideways and it fits against the wall nicely. Overall it's pretty nice. A bit pricey, but you get what you pay for.
-
Very stable and we'll constructed
-
Excellent deal, good carburetor and spark plug plus air filter and primer bulbs including fuel lines, very good deal at economical price .
-
This carrier works very well to store/transport my 8 HP Mercury motor.