Reviews

Thus is a solid design, 10 minutes start to finish to assemble. Nice to see good hardware with self locking nuts. Depending on which motor your mounting, you may want to consider lowering the board to bring the CoG down a bit.

Thus is a solid design, 10 minutes start to finish to assemble. Nice to see good hardware with self locking nuts. Depending on which motor your mounting, you may want to consider lowering the board to bring the CoG down a bit.

Product is perfect for it’ Intended purpose. Strong enough to easily hold 30 hp motor for storage or moving. I use it to keep my motor inside during the winter. When motor goes back on boat folds up for easy storage.

Howdy, the stand could be much easier to assemble if parts were actually called out with sizes AND had a decent groove in slot for a driver.That being said, when you dump the parts out take a marker and actually measure them and mark the longest ones. Itll save a bunch of time.I took this 150 pound beast and clamped it to the board and strapped it so it wouldn't turn and rolled it upright using the rounded edges of the stand.Image shows a 1960 merc kiekhaefer 400s next to a 1865 ish boat.Would I buy it again?Yes, in fact I just did for another project....Actually had to buy from another source as these folks were out.

Perfect fit for my 5hp Nissan/Tohatsu. It's pretty well built and sturdy enough tilt the engine with no problems. In a review someone had suggested finding a picture of one online to help with assembly. I would like to thank them! With the included directions and Picture it was pretty straight forward. It took about 30mins to put together.It fit easily though a standard door frame and the handle folds down for storage. You can turn the engine sideways and it fits against the wall nicely. Overall it's pretty nice. A bit pricey, but you get what you pay for.

Very stable and we'll constructed

Excellent deal, good carburetor and spark plug plus air filter and primer bulbs including fuel lines, very good deal at economical price .

This carrier works very well to store/transport my 8 HP Mercury motor.

Taken this thing out for 14 hours a day two to three time a week for a few months. Worst storms of the decade happened flooded the rivers. I got a 6hp motor on it and it goes right over all the logs and spears in the river no sign of wear so far. My fool of a Took brother even drove the thing onto the rough bed rock bank while he was looking at the fish finder. 10 mph into that bank with about 600 lbs of people and gear in it and it came out no worse for wear.

Boat is made Very well and great quality! I have looked around for an inflatable that was made of good quality and welded seems and this one had everything i wanted! i have used it a few time and was very impressed! Its extremely sturdy with the hard floor i can stand wile the boat is in movement! it is very easy to set up takes about 15-20 min by itself

Works great! Have wheeled around my 200 lb Mercury 50 HP engine around garage and seems fine. It wiggles slightly but confident it will hold up just fine. I'm sure a spendy one would be a little sturdier but this works fine for doing basic maintenance. Gave it 4 stars on assembly as there are no instructions, only a picture to follow but not too difficult to figure out.

My older stand was too flimsy and now holds my trolling motor. The new stand arrived almost 3 weeks early--kudos to the vendor! It was nicely packaged with no missing parts.All in all, I'm a very satisfied customer!