Outboard Motor Stand
Reviews by category
-
Taken this thing out for 14 hours a day two to three time a week for a few months. Worst storms of the decade happened flooded the rivers. I got a 6hp motor on it and it goes right over all the logs and spears in the river no sign of wear so far. My fool of a Took brother even drove the thing onto the rough bed rock bank while he was looking at the fish finder. 10 mph into that bank with about 600 lbs of people and gear in it and it came out no worse for wear.
-
Boat is made Very well and great quality! I have looked around for an inflatable that was made of good quality and welded seems and this one had everything i wanted! i have used it a few time and was very impressed! Its extremely sturdy with the hard floor i can stand wile the boat is in movement! it is very easy to set up takes about 15-20 min by itself
-
Works great! Have wheeled around my 200 lb Mercury 50 HP engine around garage and seems fine. It wiggles slightly but confident it will hold up just fine. I'm sure a spendy one would be a little sturdier but this works fine for doing basic maintenance. Gave it 4 stars on assembly as there are no instructions, only a picture to follow but not too difficult to figure out.
-
My older stand was too flimsy and now holds my trolling motor. The new stand arrived almost 3 weeks early--kudos to the vendor! It was nicely packaged with no missing parts.All in all, I'm a very satisfied customer!
-
This stand is great! Sturdy, strong and makes life so much easier wheeling around outboard. It’s relatively easy to put together although directions aren’t that great.Definitely would buy another if I needed to
-
My husband assemble it, however the instruction paper is so small, hope they will make it bigger and clear.Few washer are missing that he needs to buy it. I dont know if its included.The product works well as you could see it in the picture.
-
Verified PurchaseGreat investment motor fits on nicelyThe only down fall is the board 2x10 is cracked where they put one set of drill holes.I will have to replace the board at some point but otherwise very sturdy. Makes moving and storing a lot easier.
-
Reviewed in Canada on October 21, 2020Thus is a solid design, 10 minutes start to finish to assemble. Nice to see good hardware with self locking nuts. Depending on which motor your mounting, you may want to consider lowering the board to bring the CoG down a bit.
-
I bought this for my 2 hp Honda outboard to move around the garage and to hold the engine when I am cleaning the engine after a day on the water. The cart holds the engine while I have a container of water between the supports.
-
I'm satisfied with my order, setting it up took me about an 30 minutes and the instructions are pretty self explanatory.It fits my 4hp Honda outboard really well and makes it very easy to transport and also flush if needed.
-
Awesome product. Strong, well made, easily adjustable.
-
Awesome stand. Very well motor stand Swivel wheels make it nice because you can move it side ways if you need to. Nothing but good things to say about this stand. Easy assembly. Just make sure not to tighten all the bolts until it is fully assembled